Tethered power system for the DJI Matrice 400: the ground station converts mains power into high-voltage DC and sends it up to the airborne unit, sustaining propulsion and payload for continuous flight with no battery limit. Output power of 4.5 kW, a 110 m cable extendable to 200 m, and video transmission to the ground over the same cable, independent of the radio link.
| 4.5 kWOutput Power | 200 mMaximum Cable | 24/7Continuous Flight | IP44Protection Rating |
The principle is simple: the energy stays on the ground and travels up the cable. What changes is how the work is done, because the constraint that governs every battery mission — time — disappears.
A battery drone on a night surveillance task gives twenty minutes of flight and ten of battery swap, repeated all night. Tethering changes the arithmetic: one climb, no landings, nobody tied up rotating batteries.
This is what separates the system from a plain tethered power supply. The tether does not only carry energy upward: it brings the aircraft’s video stream back down, on a dedicated bandwidth that shares nothing with the drone’s radio link.
The airborne unit takes the high voltage from the cable, brings it back to 50 V and distributes it. It is more than a converter: it is where the system makes the power coming up from the ground available, through dedicated ports sized for lighting loads.
All connections are grouped on the rear face of the unit. This is where the system’s real lighting capability can be read: 1600 W combined across the two matrix ports, plus 300 W dedicated to the gimbal light, on top of what aircraft and payload require.
The ports are protected by sealed covers, and the body is drilled for the retaining straps that secure the wiring along the landing gear bars.
The Tethered DJI Matrice 400 is a tethered power system designed specifically for the DJI Matrice 400. The ground station draws current from mains or a generator at 176–264 V AC, converts it to 800 V DC and sends it along the cable to the airborne unit, which brings it back to 50 V and delivers a rated 4000 W to aircraft and payload. Output power available at the station is 4.5 kW.
The operational result is continuous flight: as long as there is power on the ground the aircraft stays up, with no landings to change batteries and no gaps in surveillance coverage. The supplied cable is 110 metres long, extendable to 200 metres as an option, weighs 1.25 kg per 100 metres and has a tensile strength above 50 kg. Recommended altitude is 100 metres with the 110 m cable and 190 metres with the 200 m cable. Cable tension control offers an automatic mode and two fixed levels, with residual cable detection.
The tether carries more than energy. The aircraft’s video stream comes down the same cable, with 100 Mbit/s of dedicated bandwidth and HDMI and Ethernet outputs on the station: the signal reaches the monitor or the control room network without depending on radio conditions at the site. The airborne unit takes the video from the payload over a Type-C interface. Management runs from the DJI remote controller, where the high voltage is switched on, real-time parameters are read, the lights are operated and cable recovery is called, or from the station’s 5.5-inch 1920 × 1080 display. The station weighs under 13 kg with 110 metres of cable on board, carries an IP44 protection rating, operates from -20°C to +50°C up to 4000 metres, and integrates a backup battery, a 65 W Type-C port with PD 3.0 and QC, a speaker and a grounding rod. Supplied by DroneBase, DJI Gold 5 Dealer certified ISO 9001:2015, with installation, commissioning, operational training and ENAC/EASA consultancy.
This is the accessory that on its own justifies moving to a tethered platform. Through the two matrix ports on the airborne unit the system makes 1600 W combined available for lighting, plus 300 W dedicated to the gimbal light: a draw no on-board battery could sustain for more than a few minutes, and which — with energy coming up from the ground — stays available all night long.
How long can it stay airborne?
What altitude can it reach?
How does the video reach the ground?
Is the drone’s radio link still needed?
Does the cable interfere with the aircraft?
How much light does the lighting system give?
What precautions are needed before use?
What support does DroneBase provide?
Continuous 24/7 flight with no battery changes · 4.5 kW of power · 110 m cable, up to 200 m · Video up to 4K over the tether with HDMI and Ethernet outputs · 5.5″ display · IP44 · LED matrix lighting system available as an accessory
★ DJI Gold 5 DealerISO 9001:2015DJI Matrice 4004K video over cable
There are no reviews yet.